| COUNTERTOPS |
Finish |
Matte/Satin |
Semi-Gloss |
Hi-Gloss |
|
| Cleaning |
| Most
dirt & stains |
Use soapy
water or ammonia based cleaner. |
| Water
marks |
Wipe with
damp cloth; towel dry. |
| Difficult
stains |
Use an abrasive
cleaner and a green Scotch-Brite* pad. |
Use Soft
Scrub** or diluted bleach and a white Scotch-Brite pad. |
Follow procedure
for semi-gloss, but use a sponge instead of a Scotch-Brite pad,
or use white polishing compound. |
| Disinfecting |
Occasionally
wipe surface with diluted household bleach (1 part water/1 part
bleach) |
| Maintenance |
Rub
with Scotch-Brite pad alone |
|
|
|
| SINKS |
| Finish: |
Matte/Satin |
| Cleaning |
Same as
above. |
| Disinfecting |
Same as
above. |
| Maintenance |
Occasionally
clean by filling the sink one-quarter full with a 50/50 water/bleach
solution. Let soak for 15 minutes, and then wash sides and bottom
as solution drains. |
|
| REMOVING
CUTS & SCRATCHES |
| Finish: |
Matte/Satin |
Semi-Gloss |
Hi-Gloss |
| |
Sand with
180 or 220 grit fine sandpaper until cut is gone. |
Sand with
400 grit sandpaper. |
Sand with
400 grit sandpaper. |
| Restore
finish with an abrasive cleanser and a green Scotch-Brite pad. |
Restore
finish with non-abrasive cleanser and a white Scotch-Brite pad. |
Wipe
the surface and continue with 600 grit sandpaper. |
| |
|
Buff
with white polishing compound and a low-speed (1,500-2,000 rpm)
polisher equipped with a wool pad. |
|
*Registered
trademark of the 3M Company.
**Registered
trademark of the Clorox Company. |
|
